Saten alçısı – Satin finishing Plaster
Saten alçısı – saten perdah alçı – saten alcisi – Saten alci – Iran gypsum plaster semnan espandar company
Satin finishing gypsum plaster powder
Preparation of Mortar :
Fill a clean container with 18-20 liter water for each 30 kg bag of the product. then pure the gypsum in the water slowly until covering the surface of the water . wait for 2-3 minutes for floating gypsum to sink by soaking. Mix water and gypsum at a low speed by a mechanical mixer until a proper mixture is obtained.
Instructions:
Surface of the gypsum application area and also tools surface must be clean ( dust, oil and small particles should be removed from surface of the work ).
It is better to have a good balance of work and holes and bumps made possible by the work surface.
Weight : 30Kg
Packing : ADstar waterproof
For export to Turkmenistan, russia, ermenista, azerbaijan and any countries
Satin finishing plaster – finishing plaster application
application surface must be cleand of dust , grease , paint etc 60 meterials , mortar , which is ready for applicatin , may be used for about minutes , it is applied by means of scraping from bottom to top and from right to be in two direction , via steel trowel , by which finishing is ensured. in this phase , care must be taken for the steel trowel not to leave any marks. when the plaster is hardened , it is ready for being painted. when the mortar becom hard , the marks are cleaned , the initial setting time of the mortar of minutes
saten perdah alcisi analysis
|
Technical specifications |
Teknik Ozellikler |
|||
|
seven litr water in ten Kg saten gypsum plaster |
Water / plaster ratio |
7 it suya 10 KG alçı |
SU / alçı orani |
|
|
120 – 160 min |
workability |
120 – 160 dakia |
Kullanim suresi |
|
|
300 – 350 min |
Final setting time |
300 – 350 dakia |
Donma suresi |
|
|
0.2 – 0.4 KG/m2 |
Consumption |
0.2 – 0.4 KG/m2 |
Tuketim Miktari |
|
|
> 3 N / mm2 |
Consumption streeth |
> 3 N / mm2 |
Basinc Dayanimi |
|
|
680 – 720 KG / m3 |
Dry density |
680 – 720 KG / m3 |
Kuru Birim Agirligi |
|
|
A 1 According 13279 – 1 |
Fire classifacation |
A 1 tsen 13279 |
Yangina Tepki |
|
|
TS EN 13279 – 1 TS EN 13279 – 2 |
Reference standart |
|
||